A licensed air conditioning contractor. TDLR's FAQ asks whether unlicensed persons can perform installation, maintenance and repairs on mini-split units and answers in one word: no. The three-ton exemption people quote applies to window units and other self-contained equipment, not to a system with an indoor head and an outdoor unit joined by refrigerant lines.
What the exemption says, and what it does not
Texas law exempts from air conditioning contractor licensing work on "a portable or self-contained ductless air conditioning product that has a cooling capacity of three tons or less". Read quickly, that sounds like a ductless mini-split. TDLR says otherwise:
"However, this is referencing window units, self-contained thru-the-wall units such as in hotel rooms, or self-contained portable ductless units. A 'Mini-Split' AC unit is not self-contained, it is a split AC system, therefore requiring a Air Conditioning Contractor's License to perform any contracting work for the public."
The key words are "self-contained". A window unit has its whole refrigerant circuit sealed inside one box at the factory. A mini-split's circuit is completed on site, when someone connects the line set between the indoor and outdoor units. That connection is the skilled part, and it is the part the license is about.
What goes wrong on a poor install
Mini-splits are sold online with the suggestion that anyone handy can hang one. The mounting is easy enough. The refrigerant side is where installs fail:
- Flare connections. The line set joins the units with flared fittings. A flare that is slightly off, or over or under tightened, leaks slowly. The system works for a season and then does not.
- Air and moisture in the lines. The lines have to be pulled into a deep vacuum with a pump and gauge before the refrigerant is released. Skipping this leaves air and water in the circuit.
- Line length and charge. A run longer than the factory charge allows needs refrigerant added by weight.
- The drain. The indoor head makes condensate. A drain that runs uphill for an inch puts water down the wall.
The federal piece: refrigerant handling
Separate from the Texas license, EPA rules under Section 608 of the Clean Air Act require technicians who maintain, service, repair or dispose of equipment that could release refrigerant to be certified. The EPA's definition of a technician includes anyone attaching and detaching hoses and gauges to measure pressure in the appliance. So even setting state law aside, the person who connects gauges to your mini-split needs that card.
New units and the refrigerant change
The EPA's table of HFC restrictions names mini-splits specifically among residential and light commercial air conditioning and heat pump systems subject to a global warming potential limit of 700 from January 1, 2025. In practice a mini-split bought new now will run on a lower-GWP refrigerant such as R-32 or R-454B, both classed A2L. That is one more reason to have it installed by someone trained on the equipment. See our refrigerant guide.
What to ask an installer
- The TDLR license number, class and endorsement. For a house, Class B with Environmental Air covers it; Class B allows cooling systems of 25 tons and under.
- Who is doing the refrigerant work and whether they hold EPA Section 608 certification.
- How the unit was sized. ENERGY STAR says a contractor should verify the proper size with a Manual J load calculation. For a single room that is a short exercise, but it should still be done. An oversized head in a small room short-cycles.
- Whether the job needs a city permit and who pulls it. A new electrical circuit for the outdoor unit usually brings in an electrician too.
- Where the condensate goes.
If you already bought one
You are not stuck. Plenty of licensed contractors will install owner-supplied equipment, though some will not warrant it. Call around, be upfront about the brand and model, and expect to pay for the install as its own job. What you should not do is hire an unlicensed installer to make the refrigerant connections. TDLR is clear that the work takes a license, and if it leaks you will be paying a licensed contractor to redo it anyway.