Any appliance that burns fuel can make carbon monoxide. It becomes a danger indoors when the appliance is burning badly or its exhaust is not getting outside. Both are things a yearly inspection is meant to catch.
The sources the EPA lists
Among the indoor sources of carbon monoxide the EPA names:
- leaking chimneys and furnaces
- back-drafting from furnaces, gas water heaters, wood stoves and fireplaces
- unvented kerosene and gas space heaters
- gas stoves
- generators and other gasoline powered equipment
- automobile exhaust from attached garages
It adds a line that matters for anyone with an older furnace: worn or poorly adjusted and maintained combustion devices, such as boilers and furnaces, can be significant sources, as can a flue that is improperly sized, blocked, disconnected or leaking.
Back-drafting, in plain terms
A natural-draft furnace or water heater relies on hot exhaust rising up the flue. If the house is pulling air out faster than it can get in, through a big kitchen hood, a dryer and bathroom fans all running, the flue can reverse and spill exhaust into the room. This is why a flue that worked for thirty years can start misbehaving after the house is tightened up or a powerful range hood goes in. If you are making either change, tell your heating contractor.
What exposure feels like
The EPA describes the effects by level. At low concentrations: fatigue in healthy people and chest pain in people with heart disease. At moderate concentrations: angina, impaired vision and reduced brain function. Higher levels are worse and can be fatal.
The trap is that the early symptoms feel like being run down. If everyone in the house feels better when they are away from it, take that seriously.
The EPA's steps to reduce exposure
- Keep gas appliances properly adjusted.
- Have a trained professional inspect, clean and tune up the central heating system, including furnaces, flues and chimneys, every year. Repair any leaks promptly.
- Do not idle the car inside the garage.
- Make certain the doors on wood stoves fit tightly.
The EPA's carbon monoxide page also points to guidance on carbon monoxide alarms. Fit them, test them, and replace them on the schedule printed on the unit.
What to ask at the yearly heating check
ENERGY STAR's maintenance checklist says the heating visit should cover gas connections, gas pressure, burner combustion and the heat exchanger, and notes that a dirty burner or cracked heat exchanger causes improper burner operation. Ask the technician three things:
- Did you inspect the flue all the way to where it leaves the house, and the water heater's draft hood too?
- What did the burner flame and combustion check show?
- Did you look at the heat exchanger, and how?
If you are told the heat exchanger is cracked and the furnace must be shut off, that may well be right. It is also a finding you are entitled to see for yourself, and a second licensed contractor can confirm it the same week.
If an alarm sounds or you suspect exposure
Get everyone outside into fresh air first and call for help from there. Do not go back in to open windows or hunt for the source. Have the appliances and flues checked by a licensed contractor before they are used again.
Who does this work in Texas
Furnaces and their venting fall under a TDLR air conditioning contractor license. Gas water heaters and gas piping are plumbing, under a Responsible Master Plumber. A house with both appliances sharing a flue may need both trades to look at it.