Flow&Furnace
Heating and cooling

What a real AC and furnace tune-up includes

Cooling gets checked in spring and heating in fall, before the contractors get busy. That is ENERGY STAR's advice, and it suggests tying the two visits to the clock changes so you remember. What matters more than the date is what the technician does while there.

The checklist

ENERGY STAR publishes what a typical maintenance check-up should include. Print it, or pull it up on your phone, and ask the technician to walk you through what was done.

Every visit

  • Thermostat settings, so the system keeps you comfortable at home and saves energy while you are away.
  • Electrical connections tightened, with voltage and current measured on motors. Faulty connections can cause unsafe operation and shorten the life of major components.
  • Moving parts lubricated. Friction in motors raises the electricity you use.
  • Condensate drain inspected. A plugged drain can cause water damage in the house and affect indoor humidity. In a Texas attic install this is the item that ruins ceilings.
  • Controls and starting cycle checked, to see that the system starts, runs and shuts off properly.

Cooling

  • Evaporator and condenser coils cleaned. Dirty coils make the system run longer.
  • Refrigerant level checked and adjusted if necessary. Too much or too little makes the system less efficient and shortens its life.
  • Blower components cleaned and adjusted. ENERGY STAR says airflow problems can reduce a system's efficiency by up to 15 percent.

Heating

  • Gas or oil connections, gas pressure, burner combustion and the heat exchanger checked. Improperly operating connections are a fire hazard and can contribute to health problems. A dirty burner or cracked heat exchanger causes improper burner operation.

Your part: the filter

ENERGY STAR's instruction for homeowners is to inspect, clean or change air filters once a month in a central air conditioner, furnace or heat pump. A dirty filter can increase energy costs and damage the equipment, leading to early failure. If you do not know where yours is or which way it faces, ask the technician to show you. That is a five-minute lesson that pays for the visit.

Why the heating check is a safety check

The EPA lists worn or poorly adjusted and maintained combustion devices, such as boilers and furnaces, among the sources of carbon monoxide in a home, along with flues that are improperly sized, blocked, disconnected or leaking. Its advice is to have a trained professional inspect, clean and tune up the central heating system, including furnaces, flues and chimneys, every year, and to repair any leaks promptly. Our carbon monoxide guide has more.

Tune-up or sales call?

A low-priced "tune-up" is sometimes a way to get a salesperson into the house. Some signs you are getting the real thing:

  • The technician takes the panels off and uses gauges and a meter. A flashlight tour is not a tune-up.
  • You get readings in writing, not just a tick-box sheet.
  • A recommended repair comes with the part shown to you and the measurement that condemns it.
  • "Needs refrigerant" comes with an answer to the next question: where did the old charge go? Refrigerant is not used up. If the level is low, there is a leak.

If the visit ends with a quote for a whole new system, get a second opinion before you decide, and read our guide on repairing or replacing.

Who should be doing it

In Texas the company needs a TDLR air conditioning contractor license, and anyone handling refrigerant needs EPA Section 608 certification. Ask for the license number when you book.

Sources

Looking for someone licensed to do the work? Start at the Texas, Connecticut or Colorado hub. Reviewed against the linked sources in November 2026.

Keep reading