If your house was built before 1986, some part of its plumbing may contain lead. The most significant source, where it exists, is the service line that runs from the water main to the house. Your water utility is the first call, because it either knows what that line is made of or is working on finding out.
Where the lead is
The EPA says lead pipes are typically the most significant source of lead in the water where they are present, and that lead pipes are more likely to be found in older cities and homes built before 1986. Among homes without lead service lines, the most common problem is brass or chrome-plated brass faucets and plumbing with lead solder.
So there are three places to think about:
- The service line, from the main to your house. Part of it may belong to the utility and part to you.
- Solder on copper joints inside the house.
- Brass fittings and faucets.
What "lead free" has meant
| Period | Pipes and fittings | Solder and flux |
|---|---|---|
| From the 1986 amendments | No more than 8 percent lead | No more than 0.2 percent lead |
| Current | Weighted average of 0.25 percent across wetted surfaces | 0.2 percent |
The 1986 amendments prohibited the use of any pipe, fitting, solder or flux that was not lead free in public water systems and in plumbing that provides water for human consumption. Two things follow. A house plumbed before then may have solder with far more lead than is allowed today. And a brass faucet sold as "lead free" under the older definition could still contain a good deal more lead than one sold now.
Why the water chemistry matters
Lead gets into water through corrosion, which the EPA describes as a dissolving or wearing away of metal caused by a chemical reaction between water and your plumbing. How much depends on the chemistry of the water, how long it sits in the pipes, and the condition of the pipe. That is why two houses on the same street with the same pipe can test differently, and why a change at the water plant can change what comes out of the tap.
What to do, in order
- Ask the utility about your service line. The EPA's advice is to find out whether the pipe that connects your home to the water main is made from lead, and it publishes a step by step guide called Protect Your Tap for checking the pipe where it enters the house.
- Have the water tested. The EPA says to contact your water utility to have your water tested and to learn more about lead levels in your drinking water.
- Flush before you drink. If water has been sitting, run the tap, take a shower, or do laundry or dishes first. How long to run it depends on whether you have a lead service line and how long it is; the EPA says to ask your utility for the flushing time it recommends in your community.
- Watch for digging. If you have a lead service line, the EPA warns that nearby construction or maintenance can disturb it and suddenly release more lead. Ask the utility what work is planned on your street.
Where a plumber comes in
Replacing the customer side of a service line, or the old soldered copper inside the house, is plumbing work that needs a permit in a Texas city that regulates plumbing. Coordinate with the utility so its side and your side are replaced together if both are lead; replacing half a lead line and leaving the other half in the ground is the worst of both.
When you get quotes, ask the plumber to show you the materials that will go in and to confirm they meet the current lead free standard. Any reputable supply house sells nothing else for drinking water, but it costs nothing to ask. For the whole-house version of this job, see repiping a house.