Flow&Furnace
Plumbing

Repiping a house: when it is time and what to ask

A repipe replaces the water supply piping in a house from the point where the service enters to every fixture. It is the plumbing job people put off longest and regret least. The decision usually comes down to arithmetic: when you are paying for a third or fourth leak repair on the same old pipe, you are renting the problem.

Signs the pipe, not the fitting, is the problem

  • Leaks that show up in different places along the same material, not at one bad joint.
  • Rusty or discolored water after the house has sat empty for a day.
  • Pressure that has dropped over the years at fixtures far from the meter.
  • A water meter that moves when every tap is off. The EPA's leak check is simple: read the meter, use no water for two hours, read it again. If it changed, you probably have a leak.

One leak is a repair. A pattern is a pipe at the end of its life. The EPA says the average household's leaks can account for more than 9,300 gallons of wasted water a year, and that is before a slab leak or a burst.

Older houses and lead

If the house dates from before the mid 1980s, ask the plumber to look at the solder and the service line while the walls are open. The EPA says lead pipes are more likely to be found in older cities and homes built before 1986, the year Congress amended the Safe Drinking Water Act to prohibit pipes, solder or flux that were not "lead free" in plumbing that provides water for human consumption. Back then "lead free" still allowed pipe with up to 8 percent lead. Today the limit is a weighted average of 0.25 percent across the wetted surfaces of pipes and fittings, and 0.2 percent for solder and flux.

A repipe inside the house does not replace the service line from the main. If that line is lead, your water utility is the first call. Our guide to lead pipes and solder covers how to find out.

How the job runs

Most whole-house repipes follow the same order. The crew maps the fixtures and decides the routes, which in a slab house often means taking new lines overhead through the attic and down the walls. They cut access holes, run and secure the new pipe, and connect it fixture by fixture so the water is off for hours at a time, not days. Then comes the pressure test and the inspection, and only after that the drywall patching. If a quote has the patching before the inspection, ask why.

Ask what material is proposed and why it suits your water and your house. A good plumber has a reason that is about your job: attic runs and freeze exposure, water chemistry, access. "It is what we always use" is not a reason.

The permit, in Texas

A repipe is permit work in any Texas city that regulates plumbing. The Plumbing License Law says a municipality that adopts a plumbing ordinance must require a permit before plumbing is performed, other than repairing leaks and replacing faucets, ballcocks or water control valves, garbage disposals and toilets. New piping through the house is none of those. The inspection has to be done by a licensed plumbing inspector.

The Texas State Board of Plumbing Examiners makes the company's Responsible Master Plumber responsible for obtaining the permits and requesting the inspections. So the permit should be in the plumber's name, not yours, and the price should include it.

What to ask before you sign

  1. Who is the Responsible Master Plumber, and what is the license number? Check it on the Board's lookup.
  2. Is the permit and the inspection in the price?
  3. Which lines are included: hot and cold, the line to the water heater, hose bibbs, the ice maker?
  4. Where will the access holes be, and who patches and paints them?
  5. How long is the water off each day?
  6. What is the plan if the crew finds a problem with the service line or the main shutoff?

Sources

Looking for someone licensed to do the work? Start at the Texas, Connecticut or Colorado hub. Reviewed against the linked sources in November 2026.

Keep reading